To ensure that the mower functions optimally, it is necessary to carry out certain inspection preparations before use. Begin by placing the equipment on a horizontal surface. Firstly, check the diesel fuel and refrigeration storage tanks. Then, open the water tank and add an appropriate amount of circulating water in accordance with the guidelines. Once complete, cover the water tank cap. Following this, open the oil cap and add gasoline and diesel as per the prescribed regulations. The tank need not be full. Ensure that the oil cap is twisted shut. Next, check the tire pressure and pump them up if necessary. Examine the cutting disc and ensure that the cutter is intact. Check that the transmission belt of each transmission system is not damaged, and the clamping wheel works properly. If not, make sure to replace or adjust it immediately. Before starting the mower, place the transmission clutch rocker and the cutting clutch rocker into the separation part, and put the gear rocker into the neutral part. Loosen the cutting clamp wheel and put it into the walking part. The accelerator pedal rocker should be in the middle part. After starting the car engine with the crank handle, slowly increase the accelerator pedal. Push the transmission clutch rocker into the fusion part. If the mower is being used in areas closer to the village, it can be autonomously driven to its destination. However, if the distance is far, it should be carried by a carrier due to its slow speed.
When heading to the field, the lawn mower may require further adjustments once it has arrived. To achieve this, one may adjust the wheelbase of the two walking wheels. If the lawn's incline is steeper, then a wider wheelbase is ideal to ensure maximum stability on the ground. Furthermore, it is necessary to adjust the cutting fixture wheel to achieve the appropriate stubble height to width ratio, and this can be done by adjusting the two dowel parts. To achieve this, one needs to tighten the coupling dowel of the tool head on the spindle and on the protective cover. Afterward, put both the clutches into the separation part and hang the neutral part. Start the car engine and add more acceleration gradually, connecting the cutting clutch rocker, and let the cutting disc run. Finally, fuse the transmission clutch and select a low-speed forward gear as you begin the ground work.